AEM V3 1 Gallon Water/Methanol Injection Kit (Internal Map)

The new controller designs feature large, turn-resistant knobs and larger numbering to easily set accurate start and full activation points, with covered status LED and test buttons for added splash resistance. A plug is integrated into the controller housing for mating to the redesigned wiring harness's positive-lock connector. The Boost Dependent controller housing has a molded-in, barbed nipple to accept a boost hose and a wiring legend on the back. The Multi Input controller has an easy-to-remove plug covering the programming dipswitches and a programming legend on the back for the 0-5v and frequency based settings. Both controller housings feature an easy to access integrated fuse and molded mounting tabs.
V2 Water/Methanol Injection Kit, Standard Controller - Internal MAP with 35psi max, 200psi WM Pump, 1.15 Gallon Reservoir, Conductive Fluid Level Sensor

• Terminated harness features positive lock connector with integrated pump ground circuit and additional wire for optional on/off flow solenoid


• Three interchangeable injector nozzles to cover a wide variety of HP levels (250cc/min, 500 cc/min & 1,000cc/min)


• 30-3350 Multi Input kit for high compression naturally aspirated and forced induction applications


• 30-3300 Boost Dependent kit (up to 35PSI) includes molded-in nipple for boost hose


• One machined billet injector with integral check valve to prevent unintended flow


• Recirculation-style pump with integral fittings for quiet operation


• Covered status LED and test button for improved splash resistance


• 1-gallon tank with built-in conductive low fluid level indicator


• Integrated plug for mating to positive-lock connector on harness


• Large adjustment knobs and numbering for easy programming


• LED dash light for system status and low fluid warning


• Includes "Boost Safe" readiness failsafe system


• 20 ft. of high-pressure nylon injection tubing


• Integrated fuse and mounting tabs


• CONTROLLER FEATURES: